Odin3 v3.10.6 for Galaxy S6 & Galaxy S6 Edge

Download Odin3 v3.10.6 flasher tool for Galaxy S6 and Galaxy S6 Edge devices.  This is the suitable Odin3 version for flashing a stock firmware on all Galaxy S6 and Galaxy S6 Edge version without getting fails.

Proper Use of Odin3_v3.10.6

The Odin3 v3.10.6 can be use to restore back the Galaxy S6 and Galaxy S6 Edge to its original and official firmware. It can directly install a stock firmware either it comes in single and multiple tarball packages  It can also be use to install an individual stock firmware packages such AP, CSC, Bootloader, Modem, Stock Recovery, Stock Kernel and even a modified system images.

Odin3_v3.10.6 screenshot

Flashing single stock firmware package on Odin3_v3.10.6

If the stock firmware only comes in single binary file (.tar.md5) it can be loaded in Odin3’s AP slot. This also applies on other system images such stock recovery and the stock kernel.

Grab this version of Odin3_v3.10.6 for flashing single stock firmware and system images of which only the AP button is enabled.

Flashing Multiple stock firmware packages in Odin3_v3.10.6

Some stock firmware which comes in individual binary packages such as it Bootloader, AP, CSC, Modem and sometimes including a PIT file.  You may only load each specific packages in Odin3’s  reserved buttons.

BL = Bootloader or a Boot image
AP = AP file or a Phone  image
CP  = CP file or a Modem image
CSC = CSC file or the consumer code

For flashing multiple stock firmware packages grab this version of Odin3_v3.10.6 from which all buttons are enabled.

Reboot the Galaxy S6 and Galaxy S6 Edge in Download mode:

To be able to use Odin3_v3.10.6 properly you must set your Galaxy S6 or Galaxy S6 Edge in “Download Mode” screen. To activate the device in download mode follow this steps:
1) Turn off the phone. 
2) Press and Hold the Volume Down, Home and Power button at the same time.
3) Press Volume Up to enter the device in Download Mode. 

Enable USB debugging mode in Galaxy S6 and Galaxy S6 Edge 

You may also need to enable the USB debugging mode in your Galaxy S6 and Galaxy S6 Edge. This is a basic function of an Android device that facilitate its connection to a computer.   You can simply navigate this option in the device Settings>>Developer option>>USB debugging, then simply tick the box to enable it.

Install the Galaxy S6 and Galaxy S6 Edge USB Driver

To ensure that Odin3_v3.10.6 will work well accordingly, you must also install the proper USB driver for Galaxy S6 and Galaxy S6 Edge. Without the proper USB driver, your computer will not be able to recognize your Galaxy S6 and Galaxy S6 Edge.

Odin3_v3.10.6 Fails While Flashing

If Odin fails while flashing the stock firmware, this is mostly caused by a bad USB data cable. As long as you have properly installed the USB driver, you must check your USB data cable if it still in good condition. You may also try another PC and laptop, if somehow the Odin3_v3.10.6 still fails.

Galaxy S6 & Galaxy S6 Edge Updates, News, Smart Switch & OTA Updates, Stock Firmware, Root Guides, Tips and Tutorials.